DT1205
Posi (Limited Slip) Clutch Spreader
  • 1 Rotating Handle
  • 1 Hex Head Bolt
  • 3 Side Gear Pucks
  • 1 Hard Carrying Case

THIS IS ONE OF OUR NEWEST TOOLS THAT AUSMOR HAS BROUGHT TO THE MARKET TO MAKE MECHANICS LIFES EASIER AND TO CREATE MORE EFFICIENCY AND TIME SAVINGS!

THIS TOOL CAN BE USED ON VARIOUS POSI (LIMITED SLIP) DIFFERENTIALS. FORD 8.8 / 9.75 / CHRYSLER 9.25 / DANA 44 / DANA 60 AND THERE MAY BE MORE!

OVER TIME CLUTCHES IN A POSI UNIT WEAR OUT FOR MANY DIFFERENT REASONS, NORMAL WHERE AND TEAR, UNEQUAL TIRE PRESSURES AND ABUSE ARE JUST A FEW! IT IS EXPENSIVE TO REPLACE AN ENTIRE POSI UNIT AND MAKES SENSE TO REBUILD THEM IF YOU CAN!

THIS TOOL IS A MUST HAVE ITEM WHEN REBUILDING THESE VARIOUS POSI UNITS. WITHOUT THIS TOOL IT IS VERY DIFFICULT TO COMPRESS EACH CLUTCH PACK AND ROTATE THEM OUT AND BACK IN TO THE POSI CARRIER CASE! WITH THIS TOOL IT ACTUALLY TAKES LONGER TO SOAK THE NEW CLUTCHES IN FRICTION MODIFIER THAN IT DOES TO REMOVE THE OLD CLUTCHES AND TO INSTALL THE NEW ONES!

IF YOU ARE THINKING OF STARTING TO REBUILD THESE POSI UNITS, YOU MIGHT ALSO CONSIDER DT1204 & DT1212, THESE TOOLS WILL BE NEEDED TO PROPERLY DETERMINE WHAT THICKNESS OF SHIM YOU NEED TO INCLUDE WITH THE CLUTCH PACKS IN FORD 9.75 & 8.8 DIFFERENTIALS!

Login To View Your Pricing

Become a Customer

Actual product may vary.